The kitchen tiles are jumping between the seams and the porcelain is what s going on

Updated on Kitchen 2024-08-02
1 answers
  1. Anonymous users2024-01-24

    The main reasons for the corner jumping porcelain after the use of ceramic tiles are as follows: 1. If the tile is too narrow when paving, if the tile is too narrow when paving, after a period of use, with the slight change in temperature and humidity, it may lead to a slight expansion of the tile, which will lead to the problem of tile bulging. 2. When the tile is paved, if the dry ash layer of the base layer is not compact, the cement mortar on the back of the brick is not full and uniform, and the dry ash layer is not firmly bonded with the base layer, etc., it may cause the problem of hollow drum delamination of the tile.

    3. If there is a heating pipeline in the base layer of the tile paving area, if the heating pipeline of the ground is laid if the backfill layer is not properly handled, the delamination and hollowing will also cause the cement mortar layer above to crack, thereby causing the tile to bulge; 4. After the tile is paved, there is no walking and stepping on the brick surface before drying, which causes the loosening of the tile.

Related questions
What happens when the porcelain on the bathroom wall tiles falls off?
3 answers2024-08-02

Tile cracking caused by deformation of the wall can show regular cracks in the horizontal, vertical or diagonal directions. >>>More

What's going on with the cracked porcelain on the edge of the bathroom tile?
4 answers2024-08-02

1. The quality of the tile itself.

The bathroom is different from other spaces, usually the bathroom is a place where more water is used, so special attention should be paid when choosing tiles, usually the water absorption rate of tiles should not exceed 18%, but the water absorption rate of many tiles has reached 20%. >>>More

How do you make the gap between the ceiling and the wall? Thank you for the detailed construction
3 answers2024-08-02

If you don't use gypsum board inside, the wall is nailed with wood, and the horizontal height of the wood is higher than the height of the top. Pull the wire at both ends, make a boom on the wooden square nailed on the wall (the horizontal line is below the boom), and then paste the nailed shelf up and down to the nailed row of booms, and nail it up with a code nail gun. >>>More

What's going on with the tiles on the side wall of the balcony bulging outward?
1 answers2024-08-02

Because the balcony is the part with the strongest sensitivity to cold and warmth in all seasons, the thermal expansion and contraction vary greatly. And people don't pay attention to the balcony when decorating. The bricks used are not of high quality and cheap. >>>More

What should I do if the tile joints in the kitchen are blackened?
6 answers2024-08-02

Clean the brick joints with nails and wash them with water. Then apply it with white cement. Finally, wipe the brick surface clean. >>>More