-
Anonymous users2024-01-24Is the mop electric? Is it a vacuum cleaner?
First of all, you plug the plug into the socket in the other room, if the power is also lost, it means that there is a problem with the mop and it needs to be repaired by a professional. Because of the failure of electrical appliances, it is not good to say what the reason is.
Change a desk lamp or hair dryer to try the bathroom socket, if there is a problem, it means that there is a problem with the bathroom socket, change it, don't repair it, one is that the socket must be defective in quality, the other is that the repair is completed, it is easy to break down again, the bathroom has water, the electricity arrives, and the loss is not a socket that costs 20 yuan.
-
Anonymous users2024-01-23Your grip is short-circuited inside, and it will be short-circuited when you plug it in.
Otherwise, the quality of the toilet socket is not good, and it was replaced.
-
Anonymous users2024-01-22Why should a mop be plugged into a bathroom socket?
The neutral and ground wires of the socket are reversed. Because the neutral wire and the ground wire are ultimately grounded, the device that detects whether the socket wire sequence is correct can not detect this error, and the reaction is to light two green lights and the red light is not on, but because the ground wire does not pass through the leakage circuit breaker, the current flowing through the leakage circuit breaker when the load is connected is unbalanced, which causes tripping.
If the socket will trip as long as it is plugged into any electrical appliance, there is only one possibility in this situation, the neutral wire of the socket is connected to the ground wire, and the grounding wire is connected to the neutral wire terminal, as long as the electrical appliance is inserted, it will cause the line to be grounded, and the leakage switch will trip immediately.
First of all, your washing machine is not as simple as photocapacitor damage, removing the ground wire and not tripping means that the washing machine has leakage. Then there is the landlord must figure out the protection line and the working zero line, if the line is true, the two protection line contact should not trip, the zero line and the protection line contact will trip.
There should be no problem with the socket wiring, the key is what electrical appliance are you plugging in? Whether the main gate has a leak protection (it is extremely not recommended to use the leakage protection switch for the main switch!) If the main switch is leakaged, then the plugged electrical appliances have two possibilities: leakage and short circuit, and the problem of the socket itself cannot be ruled out (internal short circuit when the plug is inserted), and the multimeter for this fault check is useless.
As long as the sum of the current of the two sockets is not greater than the safe current of the wire in the wall.