Half of the bathroom wall is made of glass, what should I do if the wall around the glass is wet How

Workaround:

The metallic high-leg design refuses to stretch upwards from moisture.

Do not use wooden legs for the bathroom cabinet, as this will lead moisture from the floor to the cabinet during use, which will eventually cause the entire cabinet to become damp and deformed. If stainless steel is used as the leg material at the bottom of the cabinet to support the cabinet, isolate the moisture on the ground and keep the cabinet as dry as possible.

Separate the wet and dry to keep the ground dry.

If there are conditions, it is best to use the shower room, so that more contact with the wall and ground can be avoided when bathing, and the exhaust fan is best installed above the shower room, so that after the shower, close the bathroom door, and turn on the exhaust fan for a while, so that the water vapor generated by the shower can be discharged through the exhaust fan as much as possible to avoid accumulation in the bathroom.

Waterproof aluminum foil natural enemy of condensation.

In the summer, we often find that some of the water pipes in the bathroom will produce condensation, which will flow down the countertop to the bottom of the cabinet, causing the cabinet to become moldy and deformed. If you can wrap a layer of sponge on the outside of the pipe, this can reduce the formation of condensation directly on the water pipe by hot and cold gases, and add a layer of waterproof aluminum foil or rubber pad to the bottom of the cabinet, or put them at the bottom of the drawer, which can also play a role in preventing moisture.

The shower room should be cleaned in time after use.

Some people are accustomed to letting the shower room dry naturally after showering, which is actually a very bad habit, the volatilization of water on the wall and floor will aggravate the dampness of the bathroom, so be sure to wipe the wall with a dry rag after the shower, and clean up the water on the ground.

Turn on the exhaust fan regularly every day for air replacement.

We do not do engineering, but we can provide free professional technical advice on concrete waterproof leakage repair.

It is recommended to do the overall waterproofing, non-permeable construction, the base is waterproof more than 1cm, because it is the living room, it is really leaky and the gain outweighs the loss, you try K11 in the bathroom. Waterproof is good, hollow glass, now the master is very rough when doing the side seams, the glass glue is painted in a mess, the supervisor can keep an eye on it, remember to make isolation seals on the wall and the glass interface, the glass does not know whether your design is parallel to the wall or made of insulating glass, no matter what is used, the bathroom is still fully waterproof.

It doesn't matter what material you plan to use for the walls of your bathroom.

Must be waterproof.

The waterproof height of the bathroom is generally in meters. But if you care about the other half of the wall, you can fill it up.

The nozzle and the side of the door should be closed well, otherwise there will still be a problem at that time, if the place you smashed is above the meter, there is no problem, and the position of the closure can be sealed with a seal.