-
Anonymous users2024-01-24Water tank 4 is enough, directly connected to the water tank, if it is straight ahead of a few meters must be one inch, and must ensure that the water pressure of the house is large, otherwise it can not be washed off, and the embedded pipe 32 is connected with a special joint.
-
Anonymous users2024-01-23Answer: 1 The installation sequence should first study the specific direction of the waterway, the second step is to fix the clip to the wall with an electric hammer, the third step is to start to use a professional hot melt machine to hot-melt the pipe, the fourth step is to use a pressure test pump to test the pressure of the entire pipeline, the fifth step is to clean up the site2 The design and layout of the bathroom water pipe, the bathroom water pipe installation should be laid according to the direction of the water, generally horizontal and vertical, as far as possible 2 pipes do not cross, if the cross to build a bridge, the hot and cold water pipes are separated and kept at a certain distance, The left and right positions of the bath mixing valve are correct and installed in the middle of the bathtub, and the height is best between meters and meters, and the installation of the water heater and the inlet and outlet of the washing machine should be reserved to achieve a scientific and reasonable layout. 3. The pressure measurement process of the toilet water pipe should close the valve behind the water meter before the pressure test, block the tail end of the pressure test pipe and slowly inject water, seal the inspection after filling with water, and then manually boost the pressure, after the pressure is stabilized, the pressure drop within half an hour is not more than qualified.
-
Anonymous users2024-01-22No, there will be a hose connection between the water pipe and the squatting toilet, and you'd better go to someone else's place to see it, and this problem is a layman.
Generally, a return pipe is made to the boiler. There should be a circulating pump. Or the boiler itself has a circulating water function.
Go and take a closer look at the finished product or see the hydropower master install it once, and it is best to dismantle it and restore it by hand.
Features of PPR pipes:
1. Thermal insulation and energy saving (the thermal conductivity is only 1 per 200% of the metal pipe), and there is no need to do thermal insulation treatment under normal circumstances; >>>More
1. Bathroom leakage solution.
Solution 1, determine the cause of water leakage is a waterproof problem or a water pipe problem first in the bathroom to close the water, and then observe, when the water is closed, the water should be put three centimeters high, the master Bang suggested that if there is no obvious leakage trace downstairs in the process of closing the water, it means that it is not a problem with the waterproof layer, or a problem with the water pipe; If the water level drops when the water is closed, and the leakage downstairs is serious, it means that the waterproof layer is a problem. >>>More