-
Anonymous users2024-01-24This is the failure of the bathroom waterproofing, leaking water, there are two solutions.
The first is to dig up the bathroom from the upper floor and re-carry out waterproofing repairs. The advantage is that it is radical cure, and the disadvantage is that it is time-consuming and costly.
The second is to carry out leak plugging construction from the leaking water part. Generally, the process of high-pressure grouting is adopted. The construction can be completed in 1-2 hours, and the cost is several hundred yuan. The disadvantage is that only the leak point has been repaired, and the waterproofing layer of the bathroom is still ineffective.
-
Anonymous users2024-01-23Your bathroom is leaking downstairs, and here are three steps you can take to fix the problem:
1.Go downstairs to your neighbor's house to check for water leaks, and see if there are water stains, dampness, and dripping on their ceilings, walls, etc., to determine whether it is caused by water leaks in your home.
2.If it is determined that it is caused by water leakage in your home, then find a professional plumber to check whether the pipe is ruptured and caused by water leakage, etc., if it is a pipe problem, you need to replace and repair the pipe in time to solve the leakage problem.
If the possibility of pipeline leakage has been ruled out, then consider that the waterproof layer is not done well and cause water leakage, if the local water leakage is serious, it is recommended to do the waterproofing again, so that the problem can be fundamentally solved.
3.Finally, it is recommended to use a special kitchen and bathroom waterproof slurry for waterproofing in the bathroom, and then it is necessary to carry out standard construction, the bathroom needs to do all the waterproof floor, and the wall should be at least full high, and if it is a lightweight wall, then it must be done full height.
This should be the water stored below the ground, check the embedded pipe of the bathroom, whether there is leakage, the gap between the wall tiles is too large, and the floor tiles are hollow
There are two reasons, first, the waterproof project done by the developer cuts corners, and the quality of the project is too poor. >>>More
Look at the degree of humidity and the mildew resistance of diatom mud. If the humidity is relatively low, you can apply a layer of waterproof paint, and then apply diatom mud with high mildew resistance. For example, Ameri diatom mud is a mildew-resistant diatom mud certified by the national level 0.
It's useless to paste wallpaper, it's still damp and it will peel, take a hair dryer to dry, or if it's still wet, it may be a leak in the bathroom.
Peeling of the wall may be the cause of the hollowing of the stucco layer, or it may be due to the humidity of the environment or the high humidity in the room when the wall is painted, resulting in moisture resurgence. To solve this problem, the first thing is to do a good job of waterproofing the bathroom, and the specific methods are as follows: >>>More