My bathroom integrated ceiling bath bomb is like this, and now the lights at both ends are broken, I

Updated on Suspended ceilings 2024-08-27
7 answers
  1. Anonymous users2024-01-24

    From the corner of the contact between the bath bomb and the ceiling, use a flat-mouth screwdriver or a sharp point to pick off the ceiling board can be removed, and you can cut off a top plate specifically, it is very simple.

  2. Anonymous users2024-01-23

    The integrated ceiling is generally fixed by snapping, you can use a flat-mouth screwdriver to remove two pieces from the side first, you can see how the bath bomb is installed, and then remove the bath bomb to replace the lamp tube and then install it.

  3. Anonymous users2024-01-22

    The fixed surface of the aluminum gusset plate can be removed, and the bath bomb needs to be removed before it can be replaced, and it is recommended to find the property management of the community It should be able to help you solve this problem.

  4. Anonymous users2024-01-21

    The lamp covers on both sides are snap-on, you can remove them by yourself, and you can buckle them again after changing the lamp. There is no need to dismantle the kitchen ceiling.

  5. Anonymous users2024-01-20

    This one is to remove a few pieces of the top surface and change the lights from the inside.

  6. Anonymous users2024-01-19

    If you can do it yourself, you can disassemble the ceiling, and the lamp can be removed and replaced by yourself.

  7. Anonymous users2024-01-18

    wfewgwgwqgqrgeqrg

Related questions
2 answers2024-08-27

The power of the heater bath bomb is relatively large, if the capacity of the home power grid is insufficient, the line voltage drop is relatively large, etc., the terminal voltage of the circuit is too low during operation, it will show that the power is insufficient, measure the terminal voltage during operation, check step by step, troubleshoot, if the voltage in the whole area is low, there is nothing you can do.

2 answers2024-08-27

You can change one, if it is an LED flat lamp, it will not be replaced, if it is an LED light bar, it is easy to do, and the district lighting city can buy a light bar, and then you can find the original manufacturer to buy.

3 answers2024-08-27

Integrated ceiling bath bomb lamp heating is more affordable, carbon fiber can be used if you are the kind of more sealed shower room, PTC air heating and carbon fiber are about the same, but maintenance is more troublesome, choose a good brand, the price is more expensive. Don't use the gold tube alone, it doesn't have much effect. Double tube can, because the heating and average temperature are high, the requirements for the panel and body are high, and the selection of the right brand has quality assurance. >>>More

1 answers2024-08-27

The ceiling used for the decoration of my home is Aopu's, including air heating and light heating, lamps, and ventilation fans.

1 answers2024-08-27

Both Op and AIA are very good.