-
Anonymous users2024-01-24Bathroom tiling construction technology.
1. The ground is made of steel waterproofing, and the wall is brushed at the same time.
2. The floor and wall shower area are coated with flexible waterproofing. 3. Closed water test. 4. Pave wall tiles. 5. Do flexible waterproofing on the ground again. 6. Laying floor tiles.
Flexible waterproofing can be absorbed by the wall to form a protective layer, as long as there is no leakage after the closed water test, 99% will not leak in the future, I hope my interior design experience can help you.
-
Anonymous users2024-01-23The floor is padded with carpentry boards. If the wall is covered, the protective layer must be brushed.
-
Anonymous users2024-01-22The ground can be made with a transparent waterproofing agent.
The walls of bathrooms and kitchens should be flooded with cast-in-place concrete that is more than 150mm above the floor of the building. >>>More
OK. As long as the maintenance measures are good, its strength is higher than that of 108 glue. I hope my answer can help you.
1. It is basically no problem to brush the waterproof twice, and in the case of a full waterproof layer, no matter how many times you add it, it is a superfluous move. 2. The floor drain is embedded in the floor drain mouth, and there is no situation of raising the ground.
Some waterproof coatings need to be brushed, such as acrylic waterproof coatings. However, Chenguang, this type of JS waterproof coating, does not need to be brushed, and can be directly applied to tiles.
What materials did you use to waterproof your bathroom? If it is a waterproof coating or mortar waterproofing agent, then you can not knock off the non-brushing, you only need to knock off the tile to expose the cement base. Then sweep the base surface and sprinkle it with water to moisten. >>>More