-
It depends on the situation, the correct way is to brush the bottom surface 2-3 times with a waterproof layer, in order to prevent water from penetrating along the groove to the other side of the wall. Of course, if you are sure that there will be no water pipe leaks in some places (without pipe fittings), you can brush it directly on the surface. Suppress and do a closed water test.
-
The waterproof is mainly to prevent the water on the ground from leaking, and if the water pipe leaks, it is not good to waterproof.
-
Depending on whether you are looking for a large company or a small company, the general process is that the hydraulic engineer will wet the inner groove with water after slotting, and then bury the pipe after the draft is full. After the embedded pipe is pre-embedded, the groove should be sealed with mortar, and the waterproof layer should be made twice after drying.
-
After the process of water and electricity is completed, it is enough to brush the waterproof paint two or three times before preparing to paste the tiles. Whether the wall reaches the top or not depends on your conscience. , at least one meter five high must be brushed.
This problem is estimated to be a problem of quality and craftsmanship, bathroom water seepage, to remove all the floor tiles, and then use a hard brand of waterproof agent to make the ground, and on the wall to make at least a meter high waterproof material, in order to prevent water seepage. In addition, it is necessary for professionals to construct and ensure quality. >>>More
It is a tile that is laid after waterproofing, and the seam will not affect the waterproof effect, so it can be used with confidence.
According to the different types of waterproofing layers and the different functions of use, the protective layer of the roof waterproofing layer can be divided into two categories: structural protective layer and additional protective layer. The structural protective layer includes thermal insulation protection layer, swimming pool and protective layer, tail top garden, planting, etc., and the protective layer and use function of the waterproof layer are comprehensively considered. The additional protective layer is generally used for non-human roofs, including adhesion of mineral powder, coating film waterproof surface layer with light-colored paint, iron social protective layer, etc. >>>More
After the change, it is better to use waterproof paint.
The waterproofing of the bathroom must be before the decoration, the first process is to do waterproofing, and the waterproof must be tested after the waterproofing, the test time is not less than 12 hours, and the quality of waterproofing is observed. Only when the waterproof is qualified can the next process such as tiling can be carried out. After tiling or laying the floor, it cannot and cannot be waterproofed. FYI.