Clear water room decoration kitchen, bathroom, water and electricity wiring pipes

Kitchen and bathroom electrical bai

The line installation is different from other rooms, because this is a more humid place version, so the line pipe of the switch right socket must be led down from the beam and should not be laid horizontally, the socket installation height is in, all switch sockets are splash-proof safety type, the grounding wire must be connected in parallel and must not be connected in series, the height of the wall tile should be reserved when installing the wire box, and all metal items in the bathroom. For example, all kinds of metal brackets, metal floor drains, etc. must be connected to the equipotential, the equipotential connection pipe can go to the ground or wall, the exhaust fan socket should be close to the air duct, the height of the socket is 2m, and the air switch between the kitchen and bathroom must be with leakage protection. Considering that the electricity consumption of the kitchen and bathroom is relatively large, it is best to set up separate circuits in the kitchen and bathroom, if the kitchen and bathroom ceiling, the wires laid in the ceiling must be threaded through the pipe and led vertically at the socket.

As for the waterways, which are relatively simple, they can be done as usual.

Design has never been cheap, so you have to make drawings after field measurements. According to the actual situation, as for the installation of process requirements and construction methods,

The demands in your question can basically be said to be unrealistic, whether it is a bathroom or a kitchen, their shape, size, layout of internal equipment, etc., these cannot be uniform. Depending on the type of room and the location of the equipment, the direction of the water and electricity pipelines will not be the same, and it will also determine the amount of materials used. Moreover, the direction of the pipe will also be restricted by the site conditions and construction requirements.

Therefore, even if the designer depicts the direction of the pipeline, in the actual operation process, it will not coincide with the drawing due to the above reasons.

Upstairs, bai answered more completely, du The other main is the spacing of the hot and cold water pipes, the water pipe is only long enough, and the middle back is not allowed to have a joint answer, and the cold and hot water pipes in the shower room must be spaced at a distance of 15CM It is recommended to use hot water pipes for all hot water pipes The insulation sleeve for hot water pipes The wall slotting must be 1CM higher than the water pipe Hot water There is also a slotted best brush waterproof You said that the bridge and elbow should be designed according to the site.

In fact, you have been worried too much, and now you are decorating yourself.

It's all a format, the bridge you mentioned is used when the pipes overlap, and now the kitchen generally uses the kitchen treasure, so you don't need to divide the hot water pipe into the kitchen in the heavy water heater, and the outer tooth tee you mentioned is basically not used now, and now the general water heater is on one side, and the mixing valve is not together on the other side. There is also the distance of the mixing valve is medium to medium 15 cm greater than or less than can not be installed, you should consider your bathroom is lower than the living room is now how much, if the bathroom is a few centimeters lower than the living room or more than ten centimeters, whether the pipe goes underground or all on the wall,