-
Anonymous users2024-01-24Arrange all the water pipes, mortar powder grooves, if the pipes are higher than the ground, make a slope, and then make a waterproof layer as a whole after curing.
-
Anonymous users2024-01-23You do the waterproofing again after you finish the water pipe.
The place where the groove has been opened is waterproofed on one side, and the waterproof should cover the original waterproof for more than 10 cm, and then bury the thread in the groove.
It belongs to the normal damage of the construction, and it is no problem to connect it and suppress it without leakage.
If you choose an exposed pipeline, you don't have to slot, but you generally choose to install it concealedly, so you need to slot.
If the bathroom has not been paved with floor tiles, then you can not slot, the bathroom floor slotting will destroy the waterproof layer, and the future will be endless, so it is better to pave the floor tiles a little higher than to not slotted as much as possible.
This is because the waterproof of the bathroom is not caused by water leakage after changing the water and electricity, the water leakage in the living room is basically the water leakage from the bathroom, and the root cause is the leakage of the bathroom. The floor should be waterproof more than 200mm from the wall to the wall, and all around the bathroom.