-
Anonymous users2024-01-24Ask the electrician master of the decoration team to connect a wire from the switch and connect a lamp. Be sure to find a master with an electrician's certificate.
-
Anonymous users2024-01-23In the light lead a jumper to the switch that will be fine. The zero line feeds directly into the lamp.
-
Anonymous users2024-01-22The switch board on the wall only has a live wire, and the light needs a live wire and a neutral line, so see if there is a socket on the original switch board? If there is, it is convenient, just take the fire zero line out of the lamp.
-
Anonymous users2024-01-21Do you want two switches to control a light, that is, this switch can turn on and off this light, and the other switch can also turn on and off this light, this is simple, you only need these two switches to control the live line of this light, and one to control the neutral line of this light.
Pull three wires from the wall switch to the bedside switch. Both switches should be dual-controlled. The route is shown below.
This is the "ground isotope connection point", in layman's terms, the total grounding point of the room, the exposed metal shell of each electrical appliance and the electrical appliances that need to be grounded according to the provisions (through the grounding point of the socket) are concentrated here, and then the "ground isotope" reserved during the construction is connected, and the downward arrow is the grounding symbol. It has nothing to do with what smart toilet seat is, don't open it at will to avoid accidents.
The kitchen is a sunny place, and you can't hang yin things, otherwise it will not be good for your children and grandchildren (there is no future for development).
It's easy to get to your bathroom with a threading pipe, put a wire through the switch and then go to the bath bomb.
This is a damp and moldy phenomenon, and you can use a good (preferably branded, quality assurance) mold removal paint and brush it again. >>>More