-
Anonymous users2024-01-24Press the ballast with one hand, and twist the center of the lamp from side to side with the other hand to pull it out.
-
Anonymous users2024-01-23Hold the ballast with both hands and pull it out directly (the back of the ballast is connected by a pin jack), and then take the removed lamp to the hardware store to buy the same type.
-
Anonymous users2024-01-22Open the two upper bracket cards that hold the lamp, grasp the middle block and pull it down, without shaking it from side to side. Inside is a very thin plug. It's going to break. Just pull it down.
This is a special 60 30 embedded lamp for integrated ceilings, pull down at the cross junction with a sharp slotted screwdriver, and then you can disassemble the integrated ceiling on the side of the lamp, and then disassemble the lamp.
Remove the lamp, the back.
Welded sinks are generally used on stainless steel countertops. After welding, it needs to be removed and cut intelligently.
Take the circlip away, shake the lamp from side to side, and pull it out forcefully.
The corners required around the kitchen are cut according to the actual size of the wall, and the horizontal line is played on the wall, and the hole is marked every 30cm on the horizontal line, and the hole depth is about 40mm, and then the wooden wedge is driven into the hole. After that, the corners are nailed into the wooden wedges, and the corners are fastened with screws, and the corners are fastened with screws. >>>More