-
Anonymous users2024-01-24We call them door hinges or hinges.
The one that is fully covered is called the outer door, the one that is not covered is called the inner door, and the one that is half covered in the middle is called the middle door.
The door hinge hole is generally 35 mm in diameter, and the hole edge of the external door (full cover) is 5 mm from the door edge, and when adjusting, the door panel can have an adjustment range of 3-4 mm to the left and right. So your operation is no problem.
The question about the gap between the door panel and the side panels is such that the depth of the 35 mm door hinge determines the size of the gap. Generally to a depth of 12-13 mm.
Sometimes the reason for the large gap is not the punching, but the problem of assembly and ordering or blanking. I explain the specific reasons as follows: if the door with full cover is open, the seam will be large;
The full-lid door is single-opened, and the seams are standard.
That's because the neutral panel is at least 1 mm inside than the side panel, so the wider the door, the bigger the seam. If the order of the neutral plate is correct, then the problem of assembly, loosen and adjust and lock.
That's it.
-
Anonymous users2024-01-23How much is the lotus leaf that is suitable for the full cover of the furniture door in the lotus leaf groove saw, well, 3 5 cm is the most suitable.
1. ?
The distance between the bottom surface of the wall cabinet and the ground is generally about 1.6 meters, depending on the situation. Generally, the height of the base cabinet is about 800 850, and the countertop is 750 from the bottom of the wall cabinet, which is the standard range of the height range of the range hood from the gas stove. The side-draft range hood has a special installation schematic diagram, which can be designed according to his drawings. >>>More
The base cabinet is 80 cm, and the countertop is generally between 70-75 cm from the wall cabinet, of course, the specific height depends on your range hood, and it depends on the height of your family.
There is no standard for this, and it is best to set it in the center of the floor tile you are using (the brick on the side) for drainage. >>>More
The horizontal branch pipe of the balcony floor drain is generally 200mm away from the roof
The spacing between the toilet toilet water pipe and the wall is generally 650mm, according to the sewage outlet of the installed product in the appropriate position from the wall to reserve the sewer pipe and determine the distance between the sewer pipe entrance and the ground, the depth of the pit to be reserved under the ground to install the squatting toilet is greater than the height of the squatting toilet, and the connecting rubber plug should be put into the inlet hole of the squatting toilet to prevent water leakage.