How long does it take for bathroom tiles to fall off?

The wall tiles in the bathroom generally do not fall, and the tile adhesive can be maintained for a long time if it is used well. The falling of wall tiles is often due to the high water permeability of wall tiles, poor construction quality, unqualified bonding materials, and too cold weather when paving.

Ways to prevent bathroom tiles from falling off:

When the bathroom tiles are paved, the floor is paved: the uncoated cement floor tiles are laid on the ground, and after knocking it out, the cement slurry is coated with the floor tiles and paved on the ground, and the diagonal position of the four bricks is flush.

Soak more water before paving bathroom tiles: In summer, because the material is drier than usual, for floor tiles, tiles and other materials that need to be soaked in water, it is necessary to extend the time of soaking water treatment to make the water close to saturation.

Bathroom wall tiles should be fully immersed in water: due to the high moisture content of wall tiles, it is necessary to take this characteristic into account when pasting. The base layer should be fully watered and moist before tiling, otherwise, the moisture in the mortar will be quickly absorbed by the dry base layer and the tile and quickly agglomerate, which will affect its bonding fastness.

Clean the base layer before tiling: if there are lime paste, latex paint, wallpaper and other decorations on the wall, or there is dirt on the ground, it must be cleaned up, otherwise the cement mortar is not firmly bonded to the base layer; In addition, if there are cracks in the wall itself, it should be properly treated before tiling, so as to avoid cracking or falling off the wall tiles due to the enlargement of cracks in the basic structure in the future; In addition, for the ground and wall with too large a difference in flatness or verticality, cement mortar should be used for leveling. Before paving, compare the color difference of the tiles.

If the water absorption rate of the brick is too high, it may fall off in three to five years with the bath water to soak in it, but there is no problem with the selection of tiles now, and the water permeability rate is very low, so it generally will not fall Unless the weather is too cold when you lay the tiles, the indoor temperature is below zero, so the probability of falling is very high, and the hollowing rate is very high, and you can see it in one to three years.

If the materials and construction are acceptable, at least 15 years or more. My aunt's family has been using it for more than 20 years and it's fine.

If there is no problem in the construction, the tile adhesive is in place, and the tile is also a good material, it will not fall off on the day the house is demolished.

As long as the paste is appropriate, it will not fall off for a long time.

If the tile adhesive is used well, it will not fall.