-
Anonymous users2024-01-241. In the case that you can use a wooden keel or a light steel keel, try to use a light steel keel. This is because the expansion and contraction of wood is relatively large, which can easily lead to structural deformation.
2. Pay attention to expansion joints in design and construction. There should be an expansion joint at each joint, and it should be poured into a 45-degree angle to avoid stress accumulation.
3. The light steel keel or wooden keel is installed smoothly and the spacing is standardized.
4. The self-tapping nails should be evenly distributed to ensure that the force of each self-tapping nail is close to that of each self-tapping nail, otherwise it is easy to form a side-lock reaction that will cause the structure to lose stability and produce deformation cracks.
1.If it is indoor, first make the foundation of the woodworking board, and then paste the cut aluminum-plastic board with universal glue; >>>More
Personally, it is recommended to use a single staircase.
A single-run staircase is the simplest and is suitable for buildings with low floor heights. Double-run stairs are the most common, including double-run straight up, double-run twists and turns, double-run folds (parallel), etc., which are suitable for general civil buildings and industrial buildings; There are three-fold staircases, T-shaped staircases, split-and-combine types, etc., which are mostly used in public buildings; The scissor staircase consists of a pair of parallel ladders running in opposite directions. >>>More
Cement stairs can not be done step height and step width exactly the same, also need what you call the bottom, take 18 thick joinery as the bottom, be sure to buy a good joinery, when laying blockery, you must adjust the step height is not wide, the step height is high with styrofoam, after the completion of the solid plank, I hope it can help you!!
A kitchen of this shape is easy to make an integrated ceiling, as long as you find an installer to design it well.
The stainless steel lines on the ceiling should be found to be processed by the stainless steel factory, shearing, slotting, and folding to make lines.