How to do a good job of waterproofing the balcony? There are 30 points

Updated on Balcony 2024-08-17
4 answers
  1. Anonymous users2024-01-24

    The best way is to first remove the original cement plugging layer and then clean it with water. After cleaning, apply the purple gold plugging material you bought three times repeatedly, and each time you have to wait until the plugging material is dry before applying. Finally, it is leveled with cement.

    This will not leak and damp for decades, and finally I wish the landlord success, and I will not be bothered by this!

  2. Anonymous users2024-01-23

    Apply a layer of waterproof material around your nozzle and you'll be fine. You can use Liqing, which is not expensive. Most waterproofing is done with this.

  3. Anonymous users2024-01-22

    Is the seal not tight enough? Is there any sand, cement?

  4. Anonymous users2024-01-21

    Press it firmly with a pipe root sleeve at the downspout, and then make a waterproof layer with a radius of 30 cm at the downspout opening, preferably with a layer of paint and a layer of coil! Can solve the problem once and for all! Changshu heavy rain waterproofing project.

Related questions
1 answers2024-08-17

1. Sliding door waterproof In the humid and rainy south, the quality of the sliding door is often the key factor in whether it can keep the room dry. The waterproofness of the balcony sliding door should first determine the quality of the sliding door, ensure that the sealing performance of the sliding door is good, and do not make mistakes about the inside and outside directions of the door frame. >>>More

1 answers2024-08-17

It does not block the light, you can make it as big as you can, and you can even make a floor cabinet.

1 answers2024-08-17

The surface is leveled, there is no concave and convex phenomenon, use JS products to mix and brush on the surface, brush again after drying, it is best to paint evenly 3 times, close the drain after drying and discharge water to do a closed water test, 24 hours downstairs does not leak is qualified, the height of the wall coating is generally not less than 2 meters adjacent to the wall of the shower, and the position far away from the shower can be a little lower than 50CM, which is the approximate procedure.

2 answers2024-08-17

1. Remove the base surface: clean the base surface to ensure that there is no debris and no dirty oil; And moist the base surface, no open water can be; >>>More

1 answers2024-08-17

Generally, the sealed balcony can use plastic steel windows, aluminum alloy windows, broken bridge aluminum windows, solid wood windows, and hollow steel windows. The main differences between them are: >>>More