-
Anonymous users2024-01-24The installation height of the drainage floor drain in the bathroom should be 5 10mm lower than the floor surface. At the same time, temporary plugging measures should be taken when the installation is in place to prevent garbage or sand from entering the pipeline. After the installation of the pipeline riser, the hole should be plugged with fine stone concrete not lower than the cement number of the floor slab poured by the civil engineering support.
-
Anonymous users2024-01-23According to the actual design, it is nothing, and it can be changed at will.
Recently renovated, the first floor sewer pipe embedded parts are broken, you can re-open, re-open the new pipe, replace it.
It will not solve the problem at the root, and it will leak through the gap between the two pipe diameters.
Don't pick it up.
Do not rush to use, use cement. >>>More
Your drainage pipe installation method is not right, the toilet drain pipe is directly connected to the riser, the floor drain drain pipe is also directly connected to the riser, if you must connect the two in the horizontal pipe, there should be enough horizontal slope (oblique point) not to flow back, you are a private house?
Now the sewer pipes are all engineering materials Your home should be an old house It's best to change the pipes Otherwise, it will corrode Choose the floor drain Jindel floor drain The water area of the Jindel floor drain panel is more than 2800 square millimeters, plus the unique siphon function, to ensure that the drainage volume can reach up to 80l min under normal conditions, which is much greater than the municipal tap water pressure, 6 points burst pipe flow. The height of the water seal reaches the national requirement of 5cm, and the water storage capacity of the water seal exceeds 300ml, which can ensure that it does not dry up for 30 days.