-
Anonymous users2024-01-24Have you been doing it for a long time?,That's not good.。。
-
Anonymous users2024-01-23Smash the cement off, test the water on the bricks, and then occupy them with cement.
-
Anonymous users2024-01-22Don't just stick it with glue, it's not strong, use lime, sand and add some glue, so that you can get acquainted. 1. Remove the cement on the wall 2, remove the cement front on the tile and scrape it clean 3, re-make some cement and paste the tile on 4, or mix a little adhesive to increase the adhesion, it must be the original wall base treatment problem, one may be the original wall has white ash not shoveled clean, the other is that the original wall is too smooth, no frustration of the hair wheel. The third is that the original wall is too dry, and the cement of the tiles is not fully moistened before tiling.
These problems may be out of the silver to clear the phenomenon of tiles.
If the wall tiles fall off, if the area is relatively small, you can partially repair the two pieces, but if the area is relatively large, and there is still a lot of cement left on the base surface, then it is recommended that all the tiles need to be re-pasted. >>>More
If you need to remove the cement and re-brick it for more aesthetic reasons, it is better.
Add an extra lotus leaf in order to evenly divide it, and the force on the door nail will not be so great. The door frame is not very good to repair, because the material determines its load-bearing capacity, you can find a special carpenter to repair it, it may not be very beautiful, and a similar situation may occur, the wooden doors of Long Ding Tian are made of Russian white pine for internal filling, eat nail force, nail holding force is particularly good, the most important thing is that there is an anti-counterfeiting moisture-proof board, which is better used in the kitchen and bathroom.
It should also be a matter of paving. The reason is that the tiles are not soaked in place, and after paving, the cement mortar loses water during the coagulation process, resulting in the separation of the tile and the mortar. I hope my answer can help you.
If the board is not broken, 20 employees per square meter are enough.