-
Mainly depends on what the reason, I think it is the cast-in-place surface is uneven, this is not the property can be solved, this must be changed by the construction unit, this is also a common problem of the quality of the house, let the property contact the construction unit or the construction unit! Good luck!
It will be better to do a local effect ceiling.
If the top surface is uneven, it will be okay to level it with plaster.
It should be no problem to level all around! Light steel keel gypsum board ceiling 1, process specification (1) Check the installation of the concealed project of the roof, such as air conditioning system, fire sprinkler, smoke detector system, power supply and distribution system, background music and other line pipes are installed in place and concealed acceptance. (2) According to the requirements of the drawing design, the surrounding is leveled, and the middle part of the shelving is arched according to the convention. >>>More
Check with the Planning Bureau to see if the construction of this toilet has been legally planned. >>>More
According to the figure, make a shape of the same width on the wall corresponding to the low air duct ceiling position, and then make three horizontal lines with the wall between the door, and make gypsum board for the material. In the later finish, you can use latex paint to do color jumping treatment with the wall. Or it is very individualistic to paste gray mirrors on the wall modeling.