-
Anonymous users2024-01-24How to adjust the toilet float - situation 1: If you want to lower the water level in the pit, open the water inlet valve on the left side of the water tank cover and have 1 thin leather pipe called the water supply pipe, which is generally inserted into the drainage valve on the right, and pull the right side up directly in the water tank, so that the water in the pit will not be too high when the water enters the water next time.
How to adjust the toilet float - situation 2: If you want to lower the water level in the water tank, there is a threaded rod at the top of the water inlet valve on the left, and the water level of the water tank can be lowered by twisting it counterclockwise, and the water level of the water tank can be lowered when the water is added next time. Or put a brick in the water tank, which can also play a role in saving water.
How to adjust the toilet float - situation 3: When the water in the storage tank is not enough, the float sinks, the valve will be pulled and opened, and the water will flow into the storage tank. When the water is full, the float rises, the valve closes, and the water does not flow. The one that is installed next to it is the water outlet in the middle.
First of all, choose the toilet, draw a cross line in the middle of the ruler at the outlet of the toilet to the two sides and front of the toilet (the imprint can be seen on both sides and the front side after being placed flat), and then use the same method to draw a cross line in the middle of the sewer mouth with a ruler on the opposite position of the ground and the toilet (drain), and finally the line spent on the toilet is opposite to the cross line on the ground, and the glue is sealed.
The float of this toilet is the blue cylinder in this picture. It's going to go up and down.
Plastic, 1-2 yuan. Copper, more than a dozen yuan.
The inside is hollow, so it always floats on the surface of the water, and the water rises to close the inlet, and descends by gravity to open the inlet.
One end of the crossbar of the float is fixed on the column of the water tank, it may be that the fixed screw is too tight, which affects the activity of the crossbar, so that the float can not float when the water level is full, you only need to loosen the screw a little, and the crossbar can move up and down freely.