-
Anonymous users2024-01-24Find a property or developer.
-
Anonymous users2024-01-23Hello. Remove the screws that hold the doorbell button to your house. 2. Pull the button out to the allowable length of the circuit connection wire, and then release the fixing screw on the button to disconnect the wire.
Connect the two bare wire ends together. If the doorbell rings, you'll know that the fault is in the button. Install the new button by attaching two wires to the set screws of the new button, and then reinstall the button to the house.
The doorbell button is a single-pole switch (two wires are attached) and you can place the wires under their respective screws. 3. If the doorbell does not ring after connecting the two bare wire ends together, the fault may be elsewhere – the doorbell assembly, wiring, or transformer. Removing the bayonet cover of the doorbell may be more difficult than expected.
Since there are several different types of covers, you may have to try several steps, try to lift the cover slightly upwards and then pull it out; If that doesn't work, pull the cover straight out without lifting it first, or check that the bayonet cover is secured in the doorbell assembly with the pins. If yes, then press down on the prongs and pull on the cover to loosen it. Whatever you do, don't use too much force to avoid damaging the beautiful cover.
4. Once the cover is removed, look for two, three, or more terminals and wires, depending on the number of tones your home's doorbell system rings. A standard doorbell or buzzer has two wires that can be disconnected by loosening the set screw and then connecting the wire to a 12-volt multimeter or to the set screw of the spare doorbell. A cheap doorbell, a buzzer, or a 12-volt car light bulb (with an outlet and two wires) can be used for testing.
If the test doorbell, buzzer, or light bulb lights up when the doorbell button is pressed, then you will have to install a new doorbell.
-
Anonymous users2024-01-22Buy an original door, find the property and contact the developer to repair it during the warranty period.
If you install it yourself, look for after-sales service during the warranty period, and find a locksmith or door repairer outside the warranty period.
I don't know if the maintenance period of the anti-theft door Ling has passed, if it has not passed, you can arrange someone to repair, and then you can't go online to find some door-to-door service repair stations, but you must be careful to ensure its true reliability. >>>More
If it keeps ringing, it means that the switch that presses the doorbell is short-circuited, that is, it is a state that someone has been pressing, or the switch cannot be bounced when it is pressed. Can't talk to the problem.,If your doorbell is short-circuited, it is estimated that other functions will not be normal.,Now do a good job of the problem of ringing all the time.,See if there are any other problems.。。
Of course, this is the property that should be managed.
The installation time should be selected before the completion of the bricklayer, because the previous installation bricklayer and mason can be well repaired and smoothed. The installed anti-theft door will have a protective film, and you can also add another layer of protection by yourself, if it is not a human collision, it will not cause damage. >>>More
Is it your own or your unit's building intercom doorbell? If the intercom doorbell of the unit is really broken, it is not a professional who is generally not good to repair, you can contact the property, the door is installed by them, they are connected with the manufacturer of the doorbell, if there are difficulties in the property, you will see which manufacturer is the manufacturer, and contact them directly! >>>More