-
Anonymous users2024-01-24Find a bath bomb repairer to see Ha can solve it. It should be which connector is short-circuited.
-
Anonymous users2024-01-23Let's see if the light is broken... Then take a look at the opening board and test it with a pen. If it doesn't work. That could be a broken bath bomb.
-
Anonymous users2024-01-22Check whether there is voltage in the power supply of the toilet circuit.
-
Anonymous users2024-01-21The line is short-circuited, or there are fewer light bulbs! Check it out and find out!
-
Anonymous users2024-01-20It's not connected to the power supply, or the switch is broken.
The lighting line is connected to professional lighting, and the other sockets are 4 square meters all the way, and the other one is 4 square meters.
Disconnect the power supply, carefully take out the entire light board from the middle of the ceiling block, cut the power cord after loosening the gap, and then remove the whole block. >>>More
There are three power supply lines for the bath bomb switch wiring: >>>More
It may be the cause of treatment. You can find better quality ones on Taobao.
1. Precautions before changing the bath bomb lighting:
Pay attention to safety, because the height of the lamp installation is still a bit dangerous, and at the same time, you must remember to cut off the power before changing the lamp, so for safety, for the happiness of your family, it is best not to act alone, and it is best to have someone next to you. >>>More