The original ceiling elevation is 9 meters, the ceiling is 4 5 meters, how to do the reverse support

Updated on Suspended ceilings 2024-07-08
2 answers
  1. Anonymous users2024-01-24

    There are two ways: hanging the steel pipe under the embedded piece, and then using light materials, and using the lifting bar to make a light steel keel to make gypsum board.

    The lightweight material is easy to decorate, and the sky film is good.

  2. Anonymous users2024-01-23

    When the length of the suspension bar is greater than the anti-support should be arranged, the reverse support is in the case of the normal boom, from the lower end of the boom obliquely to the ceiling installation and connection of a tie rod, the tie rod should have a certain rigidity, generally 10 thick steel bars make the boom form a stable triangle.

Related questions
1 answers2024-07-08

The living room of 40 square is a relatively large area, you can hang a large square, add a circle in the middle, if the floor is relatively high, you can hang the top of the three levels more atmospheric.

2 answers2024-07-08

You can make 4 pieces of 2nd order luminous tops. The lower edge of the ceiling is flush under the beam.

1 answers2024-07-08

Self-built houses are generally used in the southwest corner to make the bathroom, and the rest of you are better to drain the window first, and then according to the light, and finally go to build the wall.

1 answers2024-07-08

This depends on what kind of roof is hung, whether it is a flat top, a modeling roof, or a mineral wool board roof. The price is not the same, generally the flat top is 180 yuan square, the lowest modeling top is 280 yuan square, and the mineral wool board top is 90 yuan square. Your 9-meter-high top has to add a shelf fee and a high-altitude work fee.

1 answers2024-07-08

If the large area is meters, the floor height is low. It is recommended that you make a perimeter ceiling and keep it high in the middle. Such visuals would be even better!