-
Anonymous users2024-01-24What you are talking about is a squatting toilet bar, not a toilet, 45 cm of the pit distance is suitable for the rear sewer, because the squatting toilet is about 60 long, the general sewer is about 1 3 position, the distance between the toilet and the wall after the installation of the front drain is about 5 cm too narrow, and the distance between the toilet and the wall after the installation of the rear sewer is about 25 cm is more appropriate, so it is appropriate to press the back drain.
-
Anonymous users2024-01-23If it is a new house, you can measure the distance from the center of the sewage hole to the wall (30CM or 40CM) after pasting the bricks, so as to go into the water after 30 and the water before 40, and some toilets have two holes after 30 and 40 before the water!
-
Anonymous users2024-01-22The hole spacing of the sewage pipe is generally 30 or 40 cm, which is the distance from the center of the sewage pipe to the wall.
-
Anonymous users2024-01-21The water is good at the back, and it is not easy to block in the toilet, which shortens the stroke of the dirt in the toilet.
-
Anonymous users2024-01-20It depends on the distance between your sewer pipe and the wall.
Two scenarios:1The ground is raised, and the pipe walks on the rough ground. 2.Blank ground groove, put a 90PPR pipe and the original 110 drainage pipe to connect. The bottom of the tank is waterproof and blocked.
Generally, it is a problem with the sewer, either something is blocked and not completely removed, or the pipe is too thin, and it is easy to clog if many people use it at the same time.
Generally, it is a problem with the toilet, the sewer pipe of the toilet is very thick, and there is generally no problem, but it may also be that the construction waste that fell into it during the renovation was blocked.
The effect is the same, the two ports are just to be able to discharge to one more place. If it is a straight-flush toilet, it uses the large thrust formed by the compressed air, and the flushing speed is fast, the punch is large, and the sewage is strong, the speed is fast, and the water is used less, and there is no leakage. Because the direct flush type uses the instantaneous strong kinetic energy of the water flow, the sound of hitting the pipe wall is relatively loud. >>>More
The sewer can use the same line as the toilet, and the sewer is designed for different purposes, and the interchange is not conducive to the toilet drainage, unless the bath water is to be recycled or the toilet is too far away from the bath drain. >>>More