The TV in the master bedroom at home is connected to the network signal, which is the kind of iTV, c

Updated on Master bedroom 2024-07-24
3 answers
  1. Anonymous users2024-01-24

    The set-top box sharer, connected with a network cable, can only watch the same unit, about 60 yuan.

    It's not bad to spend 1,000 yuan with a very small living room computer.

  2. Anonymous users2024-01-23

    No.. If you don't add it, you only split the line, and a remote control will appear to control two TVs... It's all the same.

  3. Anonymous users2024-01-22

    With a splitter, it's split in two.

Related questions
5 answers2024-07-24

The wireless network penetrates the wall to a certain extent, and it may be a problem with the router, and the signal of the poor router is worse after penetrating the wall. Either change the router or change the router. If you want to change the router, to be honest, it's basically not bad.

2 answers2024-07-24

There are two ways, one is to change to a better router, the signal should be strong, and if you have the ability, buy a router of about 200, or better. >>>More

1 answers2024-07-24

This is not surprising, the IPTV port is special, it can only be plugged into that port, can you now determine which room each of the 4 network cables on the telecom router leads to? There are mainly 3 wires, and there is one incoming wire, which is not important.

1 answers2024-07-24

An existing WiFi router can be bridged or connected in series to enhance the WiFi network.

2 answers2024-07-24

To connect the router, you need to set up the router according to the situation of the equipment connected to the front end of the network cable before it can be used, and the optical modem connected to the front end of the network cable must set up the router PPPOE dial-up, and the network cable should be plugged into the router WAN port. Connect the network cable to the router at the front, and set the WAN port to automatically obtain the IP