-
Anonymous users2024-01-24Most of them are caused by the blockage of the hot water pipe or faucet in the bathroom to reduce the amount of water, you can open the water heater mask to observe, when opening the bathroom hot water faucet, the crossbar of the water-air linkage device should not move up (open the hot water faucet between the kitchen to move up), in addition, the aging of the rubber film in the linkage device may also reduce the sensitivity and cause such problems.
-
Anonymous users2024-01-23The problem of water pressure, check it yourself, some people have a higher water pressure in the kitchen than the bathroom, and you can find a way to use the kitchen water to wash.
-
Anonymous users2024-01-22The water pressure is too small, take off the bathroom faucet and clean it to see if it works.
-
Anonymous users2024-01-21It is likely that the water pressure is not enough, and a pressurizer can be installed.
If your gas water heater is not igniting, sometimes it is not working, and there is very little hot water, you should consider whether the valve of the water heater is blocked.
It should be that the faucet in the kitchen is blocked, the water flow is small, (it is a hot melt pipe does not exclude the contents of the pipe that slip and blockage) close the valve to open the water inlet or the outlet of the faucet, clean the filter, and it should be OK after it is installed, try it.
It is related to water pressure, it is easy to start far away, the plastic film inside the gas water heater is broken, I used to use the Chigo water heater every other year, this phenomenon will appear, I have to call someone to change it once, it costs dozens of yuan, and the cost is less than a dime. . . Caused by high water temperature.
Then install an angle valve in hot water. Just find a plug in the cold water and plug it.
That's because the water out of the gas water heater when opening the faucet is the residual water in the original water heater pipeline, the pressure is not large, it looks very small, very empty, it is the residual bubbles in the pipeline, and what flows out after a while is the water that has just been opened, due to the high pressure, there are no bubbles in the pipeline, so it looks very clear!