What is the general toilet drainage slope? There is also a height of the water barrier under the bat

Updated on Bathroom 2024-07-19
5 answers
  1. Anonymous users2024-01-24

    Toilet drainage slope: there is no fixed standard, it is easy to flow water smoothly to the floor drain, and the common sense is 2*2 to see 2cm.

    The height of the water barrier under the bathroom door: 3-10 cm according to the specific situation.

  2. Anonymous users2024-01-23

    The slope is about one centimeter, and the water retaining stone is about one centimeter high. You can also ask the master bricklayer for advice, they have experience.

  3. Anonymous users2024-01-22

    THE SLOPE OF THE GENERAL TOILET DRAINAGE IS 15 DEGREES, AND THE WATER RETENTION HEIGHT IS 50MM.

  4. Anonymous users2024-01-21

    A slope of 2%-3% is enough! The height of the water barrier is generally 20-30mm

  5. Anonymous users2024-01-20

    The slope of the drainage %1 to % is sufficient, but it should be flat and there should be no standing water. The marble threshold under the door is one to two centimeters, and the lowest part can cover the bottom of the marble.

Related questions
2 answers2024-07-19

Around 5 degrees. Because there is a lot of water in the bathroom, in order to let the water flow into the floor drain as soon as possible, the ground must do a certain slope, and there is no specific regulation on the size of the slope, and the construction party will design the slope according to the requirements of the owner. The owner requires that the toilet is not waterlogged, the slope is low, and the construction is relatively simple. >>>More

1 answers2024-07-19

The height of the bathroom ceiling is related to the size of the bathroom, if the bathroom is relatively large and the ceiling is too high, it will appear empty and a little deserted. If the bathroom area is small and the ceiling is high, the tiger will appear oppressive and crowded. Therefore, the height of the ceiling should be adjusted according to the size of the bathroom >>>More

8 answers2024-07-19

The bathroom sewer pipe standard is the nominal outer diameter dn, don't correspond to that point. Generally speaking, a few points and a few inches correspond to the welded steel pipe, because the welded steel pipe is processed, the thread processed on the pipe is an inch thread, so there is a few points, a few inches, and the PVC-U sewer pipe is bonded and there is no such thing as a few points and inches. PVC-U pipes with an outer diameter of 90mm can be called 90 PVC pipes. >>>More

5 answers2024-07-19

The slope of the toilet is generally within 5 degrees, which is the national standard.

5 answers2024-07-19

Generally speaking, the standard height is 850mm for countertop and 750mm for countertop basin >>>More