-
Anonymous users2024-01-24I'm a toilet repairer in Xi'an, and I'm going to tell you the solution to the problem now:
Close the angle valve to make sure that not a single drop of water enters the tank again.
Remove the drain valve.
Wipe the water inside the tank, wipe the drain of the tank clean, and let it dry.
Clean and dry the drain valve.
After the sealing ring of the water supply and drainage valve is covered with glass glue, the drain valve is installed back into the water tank, and the angle valve can be opened after waiting for 2 hours, and the water tank will start to be filled with water.
Follow the steps above and the problem is solved.
-
Anonymous users2024-01-23First, unscrew the water outlet assembly counterclockwise by hand, then remove the rubber mat at the water outlet position, and soak it in hot water for a few minutes.
Waste about 600 ml, about 1 corner, but add up, if your toilet is broken, you should repair it, otherwise it will be a waste of water and a waste of money.
1000 watts per hour is 1 kilowatt-hour of electricity, and 1600 watts per hour is kilowatt-hour electricity, which refers to the electricity consumption of the toilet seat when it is working, and the electricity loss is very small when it is not working.
If you look at the wattage of the lamp, if it is 100 watts, it is ten hours of electricity.
That's not called a toilet, it's called a squatting toilet. In fact, whether it is a toilet or a squatting toilet, there is no quantitative amount of water used every day, mainly depending on the frequency of use by people, the more times it is used, the more water consumption is larger, and vice versa. However, you can choose a water-saving water tank, so that each flush should be about 3 liters of water. >>>More