-
Anonymous users2024-01-24Generally speaking, the solid wood floor appears black circles, and the floor is tiled or arched, which is caused by the moisture of the floor, and the reasons for the moisture of the floor are roughly as follows:
1) Keel, the raw floor is too wet. Or the quality is not good, the wood is not dry (2) the floor is not dry, and the keel is reinforced with cement.
3) Blisters (such as ruptured water pipes, balcony water backfilling, etc.).
4) Use water-based glue.
5) Too much moisture in the air, which makes the indoor moisture content unbalanced. (e.g. Huang Meitian).
6) The section where the stone floor meets the floor is not closed.
7) The first floor and other humid environments are not specially treated with moisture.
8) In addition, the solid wood floor itself and improper construction can also cause arching. For example, improper drying treatment, too low moisture content, insufficient health care, too shallow back groove, insufficient expansion joints in construction, and too tight laying.
The deformation of the solid wood floor is due to many reasons, if it is judged to be an installation problem, you can find the floor after-sales personnel: if it is a natural cause or a human cause, you need to remove the deformed floor and reinstall it.
-
Anonymous users2024-01-23There are a lot of reasons why the floor is bulging, and I'm going to give you a list of a few that you can do to see which one fits your home, and finally find out the corresponding responsibilities.
1: Paving process When paving, there must be a space of two centimeters around it, if it is close to the wall, it will definitely bulge due to thermal expansion and cold contraction.
2: The ground was not done well when doing self-leveling in the early stage, and the ground was not very flat, but this possibility was relatively small.
3: Ground moisture return The dampness of the ground can also cause the floor to bulge.
4: There is also the reason for the floor, if it is more than 120 yuan, there is basically no problem, whether it is from the environmental protection or quality, there is no problem.
The above are the important reasons for the floor bulging, I hope it will help you find the reason to restore the floor well.
The stability of multi-layer is much higher than that of pure solid wood and laminate, but it is not the best You can go to Armstrong's official website to see
Multi-layer solid wood flooring is a new type of flooring between solid wood flooring and laminate flooring, and it is a new trend in floor purchase. Multi-layer solid wood flooring retains all the advantages of natural solid wood flooring, which not only has the natural texture and elasticity of solid wood flooring, but also overcomes the common problem that natural solid wood flooring is easy to expand and shrink and deform, and has the characteristics of laminate flooring with anti-deformation, corrosion resistance and easy cleaning. So what do you need to pay attention to when buying multi-layer solid wood flooring? >>>More
Wood flooring enthusiasts have always made a trade-off between wood flooring and underfloor heating, as some non-professionals say that solid wood flooring cannot be used in underfloor heating systems. Wanjia heating cable electric floor heating expert said: "It is not that the solid wood floor can not be laid with the electric floor heating system, but the heat transfer of the wood material of the solid wood floor and other reasons lead to the heating effect of the heating system can not be fully expressed, so many professionals recommend not to use the solid wood floor." >>>More
Are you talking about red oak or white oak?
In the case of red oak, you have to pay attention, you basically can't buy it. Two hundred to three hundred for white oak is about the same. >>>More
The multi-layer flooring you are talking about is not solid wood, it should be laminate flooring. >>>More