How to stick stickers for furniture with rounded corners before it is flat

One. panel furniture.

Stickers. Before. Process. Be.

Batch ash. Putty.

Putty. Vermilion evenly applied and scraped, so that.

Plate. Surface.

Flatter. Can't have. Grain. And.

Bump. Place. The second is. Wood grain paper.

Advance as per specific requirements.

Size. Cropped.

The next sticker is on the plastered board.

Roller brushes. White latex, after the roller brush is even, put the wood grain paper on the side, and use it that is easy to press. Artifacts. As.

Dishcloth. Sweep it quickly so that it is prevented from putting it all on.

Paper. After brushing again, the inside is generated.

Bubble. After the whole paper is flattened, sweep and press a few more times to flatten the bubbles. Then cut off the excess paper, and pay attention not to warp the edge when trimming, otherwise it will affect later.

Finished product. Quality. This requires a roller brush sticker glue time.

Corner. Glue.

It needs to be enough for the paper to be glued completely.

In addition, it is necessary to pay attention to the specific requirements of the squadron wood grain paper.

Texture. Some of the requirements are texture splicing, some are two colors, and how the texture of wood grain paper will be more beautiful, and it must be arranged in advance according to the actual situation.

process. The biggest problem.

Material preparation: a large piece of cabinet sticker, a paper cutter, and a rag.

1. First of all, take a large sticker, remove the plastic film under the sticker, and leak out the adhesive surface of the sticker.

2. Place the adhesive side down and lay it flat on the flat surface of the cabinet. Then start from one side of the cabinet and slowly and firmly til it to bond the adhesive surface of the sticker to the cabinet.

3. After bonding, if there is a place that is not too peaceful, use a small scraper or cardboard shell given by the manufacturer to slowly scrape the uneven place.

4. Cut off the excess part of the sticker with a paper cutter.

5. Finally, wipe the surface of the cabinet with a clean rag.

Precautions. Once the softener has been applied, be careful not to touch or move the water sticker, as this may ruin the water sticker. When the water sticker looks wrinkled, it means that the sticker softener has worked, but it will shrink and return to flatness when it dries.

If you see air bubbles after drying, pierce it and reapply the softener. Although it doesn't work as well as the first use, it can be more or less helpful in situations where it can't be solved.

Just fold up the excess stickers and nail them to the furniture with thumbtacks and you're done.

The curved corners are heated with a hair dryer!