When the beam on the upper side of the balcony sliding door was installed, the bricklayer was not su

Updated on Balcony 2024-07-07
3 answers
  1. Anonymous users2024-01-24

    The upper track of the sliding door is directly fixed with electric hammer punching, and finally closed with neutral porcelain white glass glue, and the gap of 10mm and 20mm can be filled, so that it has the effect of leveling. Unless the size difference between the two sides of the hole in your house is too large, or the track on the sliding door is of poor quality.

  2. Anonymous users2024-01-23

    It depends on how uneven you are, if it is uneven with potholes, then use Dabai to find it, if it is one end high and one end low, you can make the upper slide of the door with the overall leveling, and the place with a gap can be filled with gypsum or glue.

  3. Anonymous users2024-01-22

    First, see if the beam is heavy, if not, you can use an electric hammer to flatten it and then install it.

    Second, if the beam can't be moved, then the only way to make the sliding door smaller.

Related questions
Is it important that the stirrups on the beams on the balcony sliding door and the stirrups on the k
1 answers2024-07-07

The impact is for sure! The size of the impact is related to the degree of cut. How big it is, no one can say! That's a matter for scientific researchers, as an engineer, the first thing is to pay attention to whether it violates the rules and whether it is qualified, and should not think about whether it can get away with it!

The beams above the sliding door in the living room are down 300 and the ceiling is 2700 high
3 answers2024-07-07

In this way, the position on the wall is only 10 cm, if you don't install the door sleeve is no problem, use the installation code with two spaces from the centimeter, the top is 3 cm from the top, and the hole below is not equipped with screws. If you install the door cover, the middle yard is changed to the top installation, and the two sides are tested. >>>More

The double glazing inside the sliding door between the living room and the balcony of the house crac
2 answers2024-07-07

Tempered glass self-explosion is a normal phenomenon! Just change it!

The wheels on the sliding doors of the furniture are broken
1 answers2024-07-07

It is mainly the lubrication and rust prevention of the slideway and the small wheel. First of all, clean the slide carefully, apply grease into the slideway and pulley, pull the door several times, the grease will penetrate into the slideway and bearing, and then pull it smoothly. Want.

How to clean the stickers on the sliding doors on the balcony
1 answers2024-07-07

You can take a dry cloth moistened with vinegar.

to cover the entire place where only the traces are attached. >>>More