-
Put the water in the pipes clean and flush it again and you'll be fine.
-
What kind of material is it, if you have cement, you can wipe it clean, if you want to use a blade, you can scrape it off with a blade, just be careful, don't hurt the pipe.
-
Answer: Please forgive me for my arrogance
-
Pipes are not sealed with tiles? So what else does it do to waterproof?
-
To be specific, is the building material sticking to the surrounding area or what?
Now there are two ways to deal with this situation of not being waterproofed: >>>More
It is recommended to redo the waterproofing. Because the effect of local single-point leakage is poor, there will be the possibility of water leakage in the future, now it is to find the problem in time when doing waterproofing, and it is better to remedy, if the tile is paved again after leakage, it is more troublesome to repair. >>>More
Redoing waterproofing means re-laying the floor tiles, removing the original tiles and cleaning the base surface. After the cement mortar is proportioned, the ground is leveled and further waterproofed. The height of the waterproof wall is controlled at about 30cm, and the wall is waterproof to better prevent the toilet from leaking. >>>More
Bathroom waterproofing must be done well, after doing a good job of 48 hours of closed water test... If it still leaks, then you need to do it again, and you must not miss it
There may be the following reasons for the old clogged bathroom: The sewer pipe in the bathroom is too small, and there is too much excrement at ordinary times, which leads to blockage. This situation can only be solved by asking workers to re-lay the pipes, which is more troublesome. >>>More