-
Anonymous users2024-01-24Exhaust, lights, bath bombs.
-
Anonymous users2024-01-23Send a picture, I'll tell you.
-
Anonymous users2024-01-221. A duplex switch has three wiring piles: two symmetrical or placed at the upper and lower ends are a pair of control piles (or called sub-piles or L1, L2), and the middle one is the main pile (L). Install 2 duplex switches on the same panel, which is what you call double control double open (with 6 holes), cancel any sub-pile of the duplex switch (idle), and only use a main pile and a sub-pile, it becomes a single control switch, so you only need to give up one hole each, it becomes two single control switches.
Connect the two main piles with wires (live wires) so that your switch can only be connected to three wires: the main piles are connected to the live wire, and the two sub-piles are connected to the lamps or can also be suspended.
Summary. First, it is required to switch to control another lamp, and the socket ensures that there is power at all times. >>>More
Just connect it according to the circuit diagram provided by the bath bomb; The original line of the bath bomb can be removed, and six wires can be placed from the bath bomb installation position to the switch installation position (if conditions permit, the color of the line can be selected white, green, red, yellow and other two-color lines, and the other two-color line is only used with one, and the other is spare) white, green, red, yellow line one end is connected to the port of the corresponding color of the bath bomb, one other color line L terminal, the other end of the white line is connected to the lighting switch, the green line, the red line is connected to the two heating switches, and the yellow wire is connected to the ventilation switch, On the terminal of the L terminal, there is a wire on the connector; The live wire of the power supply is connected to the L terminal of the bath bomb, and the neutral wire is connected to the N terminal of the bath bomb. If possible, for safety, connect a leakage switch on the power supply.
This is the bath bomb switch in the bathroom.
Summary. Hello dear, the method of connecting the living room switch is: leave a length of the wire thrown out of the box to be repaired in the future, and then cut out some cores of the wire, pay attention not to hurt the core when cutting the core. >>>More
It's all very simple, and I'll give you a picture tomorrow to look at.