-
Anonymous users2024-01-24If the access controller outputs a voltage with 12 volts, it is necessary to add a DC12 volt relay to convert it into a dry contact signal. Connect the relay NO and COM ends, when the access control card is swiped or the door button is pressed, the relay NO becomes NC induction door and is opened. If your access controller outputs a dry contact signal without 12 volts, you can directly connect the access control relay NO and COM.
-
Anonymous users2024-01-23The inner sensor remains the same, the outer sensor is removed, and you can buy a switch and connect it
-
Anonymous users2024-01-22It is not enough to connect the sensing signal cable of the external sensor to the door opening button.
-
Anonymous users2024-01-21The automatic door generally has a signal input point, and the automatic door will open when the signal input point is broken, and the button will be connected here.
When you go out, you have to add an infrared detector to detect whether someone is coming, and if someone is coming, the input point will be broken and the door will be opened.
-
Anonymous users2024-01-20Sorry, you have to press the button when you enter and exit the door with the door open.
The button is installed in a convenient place on the inside of the sensor door, and is generally the same height as the light switch.
As for how to connect, please refer to the access control host you purchased.
-
Anonymous users2024-01-19Access control requires a card or fingerprint, which should be clarified, if it is just a button to open the door, it is very simple.
-
Anonymous users2024-01-18Did you change the access control jog switch to linkage?
No, the construction is different.
There should be a button in the door that can be locked inside. >>>More
1. Easy-to-operate design:
a. The special switch for the automatic door of the disabled toilet is adopted, and the disabled can easily solve the trouble caused by the switch. The switch is designed with a large panel, and must have Braille prompts, with voice prompts and bright light prompts, which are simple and convenient to operate. It is also possible to set the foot pedal switch at a height of 200mm above the ground to realize the linkage of the switch; >>>More
Generally, infrared sensors are used, but there are also sensors such as sound and lasers.
If you want to use the living room floor to make an invisible automatic door to enter the basement, how to set it up very well? So it's not automatic.,Just directly in the living room.,Install one on it.。。