2 bathrooms share an electric water heater plumbing how to go

Nowadays, water heaters have anti-dry boiling functions, and the kitchen and bathroom do not produce hot water, which means that the water heater is not working, and further indicates that your water heater is not entering the water. Now you open the faucet or valve, the hot water valve is turned to the hottest, listen to the water heater is not working (the gas water heater will hear the sound of whirring gas burning, the electric water heater should hear the hissing sound and see the heating switch on), if you do not hear the sound of the water heater working, the water heater is not flooding, check if the pipeline is not smooth. There is also an intuitive way, first turn off the water pipe valve in the house, remove the water heater and the water pipe joint, slowly open the main valve, and see if there is water coming out of the water pipe mouth on the wall, so that you can know whether the water pipe is smooth or not.

The access pipe of the water heater only has the water inlet and the water outlet. The water outlet is generally hot water at about 70 degrees. This outlet pipe is divided into two and connected to two toilets.

Mixing valves are installed in both bathrooms. One end of the mixing valve is connected to one of the hot water pipes, and the other end is connected to the cold water pipe. The mixing valve can be connected to the shower.

Because the pipes connecting to the two bathrooms are long, it is necessary to buy a large-capacity water heater as much as possible. Every time you use the water heater, you need to drain the room temperature water in the pipe first, so when you use it, first adjust the mixing valve to the full hot water, first empty the stagnant water in the hot water pipe, and then adjust the mixing valve to a low temperature and mix cold water to a suitable temperature.

Just buy the one with the forked tube, and then connect the pipe.