-
Anonymous users2024-01-24It mainly depends on where the screws are located, in fact, it is the most direct and trouble-free to directly drill or chop the knife.
-
Anonymous users2024-01-23Knowing that Coke can wash off rust, you can use Coke to put a rag on it, and then wipe it back and forth on the screws, and then if it still doesn't work to lubricate old appliances, such as soap, it will be much better.
-
Anonymous users2024-01-22Just go to the motorcycle repair and borrow a rust remover and spray it.
-
Anonymous users2024-01-21To use the principle of thermal expansion and cold contraction, first use a happy drop screw, and then freeze it with ice cubes after 3 minutes.
-
Anonymous users2024-01-20Weld a T-shaped iron bar up, it will grow up, and unscrew it down.
-
Anonymous users2024-01-19Use pliers, screwdrivers, and hammers to warp it open.
-
Anonymous users2024-01-181 Lubricate with diesel engine oil for a period of time and unscrew.
2 If you can't open it, you will see it off.
-
Anonymous users2024-01-17Spray the anti-rust point, and then put the plate gloves on, hit the screw a few times with a hammer, and then loosen it OK
I think you asked which plastic screw buckle to copy, this position is really difficult, this kind of screw cap is generally not too tight at the beginning, just because of your position can not use force, it is recommended to find a pliers or movable wrench that can be stuck in the two protruding or left big points, the wrench is clamped and then use the metal to pull the other end of the wrench, so that it does not require much space, although the amplitude of movement will not be too large, but as long as it is loose, it should be easy to solve, as for the screws on the water pipe below you, It is best to use a fixed wrench, commonly known as a sheet wrench, which has a small range of motion and a small volume, and the plumbing material will rarely rust now, but scale will affect it.
Can't you unscrew it? If you can't unscrew it, you can go to the hardware store to buy a universal anti-rust lubricant, spray it a few times, and the rust spots of the screws will fall off, which is very easy to use, and you can remove rust and unscrew the screws.
Spray it with rust loosening agent and then tighten the screws.
It does not affect the use, does not leak, and does not need to be replaced. If the water leaks or affects the use, it can only be replaced with stainless steel wire or plastic wire wire, and it should be noted that the size of the wire model should correspond.
It's very simple, first squeeze the juice with lemon and then use a rag dipped in juice to scrub the rusty screws, so that the rust can be cleaned up first, and then use transparent nail polish to brush the exposed screw part with a layer of nail polish, which can effectively isolate the contact between oxidation and water, but this method is not the final solution, you can choose to replace the anti-rust screws if you want to cure it radically;