There are only two wires for the balcony switch light switch, and how to connect a five hole socket

Updated on Balcony 2024-07-26
5 answers
  1. Anonymous users2024-01-24

    The light switch is a wire, which cannot be connected to the socket when the power supply is used, and a complete live wire neutral wire + protective ground wire is required.

  2. Anonymous users2024-01-23

    Normal wiring can be, the wire is connected separately from the switch socket, and then divided into 2 strands of live wire and zero wire, directly connected to the socket, there is no impact, your socket is no ground wire, complementary influence.

  3. Anonymous users2024-01-22

    It shows that there is only the incoming and outgoing wires of the live wire, there is no neutral wire, if you want to install a socket, you must bring in a neutral wire.

    Connect the live wire to the L connector of the socket, and connect the neutral wire to the N connector.

  4. Anonymous users2024-01-21

    There is no neutral wire, and you can't connect to the socket unless you borrow a neutral wire from somewhere else.

  5. Anonymous users2024-01-20

    Two lines do not fulfill these two functions. You can't make a switch into a socket, and you can't do a switch when you do a socket. One wire is missing. The socket requires two wires, zero wires, and a fuse, and you need wires to turn off the light on the switch. Therefore, two lines cannot be two functions.

Related questions
How to connect two yellow wires and one blue wire to the switch in the kitchen?
2 answers2024-07-26

If the 4 wires of the wall wire box are standard electrician wiring, there should be one less red live wire, blue is the neutral wire, the yellow and green double color (one line is half yellow and half green) wire is the ground wire, and the 2 yellow wires are the controlled live wires of the original switch output, which are the power live wires that go to (supply) the two bulbs respectively.

How to put two wires into the offline pipe with two wires on the bathroom switch, the offline pipe h
1 answers2024-07-26

If there is space in the wire pipe, you can find a steel wire and use the wire in the wire pipe to wind the steel wire, pull the power cord to bring the steel wire in, and wrap the power cord to be threaded on the steel wire, (pull out one and pass it into 3 or four) Pull the wire to wear it, try it.

The living room switch has one red line and two yellow lines, and a three-open switch controls the h
2 answers2024-07-26

The third wire can only be connected to two switches, and it is enough to connect two switches. >>>More

The connection of the double control switch, the entrance switch, has two wires, one red and one blu
3 answers2024-07-26

The blue line is connected to the midpoint of the dual control switch, the red line is connected to the A line (3 wires are divided into ABC bar), the other end of the A line is connected to the midpoint of the dual control, and the BC is connected to the 1 and 3 of the dual control respectively

Six wires are connected to the toilet switch how to wiring
2 answers2024-07-26

This depends on what electrical appliances you want to connect, how many of the six wires are live wires and a few neutral wires, so you know how to connect the switch.