Urgently, please ask if there are two bathrooms to take a bath, and only in one bathroom will occur

Updated on Bathroom 2024-07-19
1 answers
  1. Anonymous users2024-01-24

    If I can rule out the leak in the floor, and it only leaks in the shower every time, I suspect that the water is leaking from the wall between the two bathrooms. When showering, water splashes down the holes in the tile joints and the inner filament bends of the walls. At first, it was absorbed by the wall, and it was not visible, but after a long time, the wall was saturated, and it began to leak down.

    You can first check whether there is water seepage at the inner wire elbow, and then find a way to seal the inner wire elbow around the inner wire elbow on the wall with glue. As for the brick joints, wait first. If that doesn't work, try re-slatting with a waterproof grout.

    If it doesn't work, you may have to pick bricks and redo the waterproofing. View the original post

Related questions
2 answers2024-07-19

Two bedrooms and one living room! Just look at the floor plan! If there is a location for a special restaurant, it is two bedrooms and two living rooms.

4 answers2024-07-19

If two bathrooms take a shower and one kitchen faucet to put hot water at the same time, a water heater of about 70 liters is generally needed. >>>More

5 answers2024-07-19

Let's use a large-capacity air energy water heater! If the distance is long, the water return device must be installed, in fact, it is good to install a water pump instead, and the water pump is equipped with a power switch to the point you need to control (I use the Matsumoto delay switch, press it, and the water pump will automatically run for a preset time and then automatically shut down), which is the most convenient, the most stable, and the cost is low. >>>More

1 answers2024-07-19

It's easy to get a new house, and you can ask for the layout and let others do what you do. When it comes to specific decorations, the most important thing to pay attention to is waterproofing. The ground is waterproof and the wall (at least meters high) is waterproof, and you can't leave dead corners, you should brush it several times, and you should carefully observe the effect when testing the water. >>>More

2 answers2024-07-19

One is the problem of water heater capacity, and the other is the problem of water pressure.