-
Let's see if it's caused by hollowing or the quality of the tiles. If it is vitrified brick on the wall, it is recommended to use tile adhesive, which will be stronger.
-
Use 502, or paste it with cement.
-
This kind of complex, if you don't want to trouble anymore, just use glass glue.
-
Structural glue Marble glue.
This is still more difficult to deal with. The specific reference is as follows: this reason depends on the carelessness of the installation master, and it is generally impossible to get the outside; It is very effective to melt the original by dropping it in place, and then quickly wash it off with water; With insulating oil, pour some insulating oil in the transformer on the clothes, the glue will soon become soft, and it can be washed off quickly; The glue is a kind of resin glue, as long as the organic solvent that dissolves the resin is used, like acetone; However, inhalation of acetone is toxic, so pay attention to how to use it.
It can only be done all over again. Reason: The gap of the bathroom tile can not be too small, the tile gap is too small to reduce the service life of the tile, and the tile is squeezed and cracked when the glaze is squeezed when it is expanded and contracted. >>>More
Soak and rinse with a mixture of soap and gasoline (without water) or apply it to the oil stain to dissolve and fall off, then wash with soapy water and rinse with water.
If it is a glue seam with 2 to 3 millimeters, you can use a sewing agent to fill the joint. If the glue joint is less than 2 to 3 millimeters, you can only shovel off the moldy one and refill the joint. Because the bathroom uses a lot of water and is damp. >>>More
The large white wall cannot be directly tiled, and the white wall will become soft and easy to fall off when damp (peeling phenomenon). Stick the tiles directly, and it won't take long for the tiles to all fall off. >>>More