Under the guidance of a master, how can you take down the square lampshade in the bathroom, the lamp

Updated on Bathroom 2024-07-29
2 answers
  1. Anonymous users2024-01-24

    Remove the ceiling next to it and put it on your hand and you should be down.

  2. Anonymous users2024-01-23

    Use the kind of small hook that can be sucked into a vacuum, and the front suction is plastic, which is pressed on the gusset or the surface of the lampshade and sucked down. There may be screws in the lampshade, so let's suck the gusset next to it first.

Related questions
2 answers2024-07-29

Landlord hello or, I am a professional Internet interior design expert, on your thing I personally put forward two ideas, first of all, the first bathroom must be large enough to install two and then take a bath, the washing area is enough to use no problem. The second is that your toilet is not the same as squatting in the water, if you have a caisson in the bathroom, it is no problem to take the roll, if there is no caisson, the squatting poop can not be installed or have to raise the ground.

1 answers2024-07-29

Dig a hole in the backsplash of the drawer, thread the power cord, secure the socket and connect it to the wire.

5 answers2024-07-29

First of all, you need to deal with the drain and floor drain, you can use silicone paint and cement 1:2 water blending and brushing, and then use silicone waterproof paint to paint two or three ways, each time before painting must be carried out on the basis of the previous drying, the façade must be turned up at least 30 cm, detailed information can be found on our website.

4 answers2024-07-29

It is recommended to seal the kitchen door and install aluminum sliding doors on the kitchen and dining room walls.

3 answers2024-07-29

Summary. Hello! The two wires of the plug, one is the live wire and the other is the neutral wire, you only need to connect the live wire pulled in from the outside to one of the binding posts of the switch, and the other binding post of the switch is connected to any wire of the exhaust fan, and the remaining one of the exhaust fans is directly connected to the zero wire. >>>More