-
Anonymous users2024-01-24The sealing strip on the security door can be glued with AB glue, rubber glue, 801 super glue, QIS-3003 special strong adhesive and other glues.
1. First of all, we need to look at the material of the sealing strip, if it is silica gel using 3009 silicone, it only takes 3 minutes; Ordinary materials can be used with AB glue, but they should be pressed for a few minutes.
2. The sealing strip is generally made of silicone material or rubber material, and there are also PVC materials, which can be made of QIS-3003 special strong adhesive, which is specialized in sticking silicone strip and rubber strip curtain wall sealing strip, with high bonding strength, waterproof and aging resistance; The sealing strip of silicone can also be sealed with QIS-5706 silicone strip special glue, which is as soft as silicone after curing.
3. The rubber sealing strip can be bonded with HY-308 glue.
4. Now the door seals are self-adhesive, first clean the pasted surface to make the surface clean, smooth, flat and dry. Then measure the height of the door and window, and cut the rubber sealing strip with scissors according to this height. Remove a short section of protective paper on the back, install the rubber seal in the correct position and press it tightly, which should be as aligned as possible with the top edge.
Constantly remove the back protective paper, so that the rubber sealing strip extends down along the frame and continues to press, pay attention not to stretch. Finally, use the same steps to install the horizontal sealing strip, pay attention to the anastomosis at the corner interface, and there should be no gaps between the joints.
Here are three ways to get rid of it.
1. Edible oil elimination method: first use edible oil to smear the area with self-adhesive, do not need too much, apply it, and it is best to pad a newspaper on the ground, because the oil droplets are easy to drip on the ground. After more than ten minutes, take a small bamboo clip for drying clothes, you can easily shovel off the sticker, and then dry it with a paper towel, if there is still a small amount that has not been removed, do it again, and finally wash the residual oil on the door with a towel dipped in soapy water, and the door will be as clean as new. >>>More
Don't replace the cat's eye, there will be a general security door, just buy one.
What to use the slogan? As far as the door is concerned, it can be said that it is a "home guard".
The hole of the first door lock, the second is the lock hole of the heaven and earth pin, if the original lock is open to each other, if the lock is changed, then use two keys.
You can still paste it, but it's best not to, first of all, it's not good-looking, and secondly, it's easy to fall off, you can put it on the wall facing the door, so that the whole living room looks spacious and bright.