Problems with the power cord in the bathroom

The bathroom depends on the needs of the owner, generally there are bath bombs, lighting, sockets, piped natural gas or electric water heater showers, you should know how many power cords there are.

It should be that there is a bare end of the power cord that causes the ignition. The power supply should be cut off in time, the exposed position should be disassembled and reconnected firmly, and then wrapped with an insulating sleeve or insulating tape.

Do a good job or install the online tube! Exposed wires will not only reduce their lifespan but are also less dangerous, let alone in the bathroom.

The extension of the power cord of the night light is very simple, because the power supply is 220V, you can simply connect the two wires to a small socket, one end to the plug, the length of the wire is up to your own needs, and the night light can be plugged into a small socket. Remove the socket part of the night light at the complicated point, weld the wire directly to the night light, do a good job of insulation, and then connect the plug at the other end of the wire, and the length of the wire is also up to you. >>>More

Just ask about the heater? Don't have a heat lamp? In that case, as long as the flat line is sufficient.