Install the washstand drill wall and drill a hole in the heat capacity pipe, how to make up for it

Updated on Washstand 2024-07-02
2 answers
  1. Anonymous users2024-01-24

    Buy a good AB all-purpose glue board, prepare a 15 mm wide, 500 mm long chemical fiber cloth strip, the specific length is determined by the diameter of the water pipe, to ensure that the water pipe hole can be wound 3 layers.

    Hollow out the bricks behind the water pipes and wrap the strips of cloth around. Remove the dust around the water pipe with a brush, scrape around the water pipe hole with a glass sheet, then adjust the glue, apply the glue at one end of the cloth strip, start winding from the bottom of the water pipe hole, tighten the cloth strip after winding, continue to apply the glue on the inside of the cloth strip, apply glue around the water pipe hole, wind upward, ensure that the water pipe hole is wound 3 layers at the water pipe hole, and wait for an hour to send water for testing. Note:

    The curing time of the glue is subject to the instructions on the hose.

    The brothers and sisters are good AB gel solidifies quickly, the operation should be fast, and it is best to practice winding before operation. The glue cannot be seen in water during operation.

  2. Anonymous users2024-01-23

    Rat King Soda beat me my Sada Wasse.

Related questions
5 answers2024-07-02

There is no need for a door around the sink, but a toilet or shower in the bathroom should be installed.

1 answers2024-07-02

If the water consumption is large, use the electricity storage type. If it's smaller, use gas. Electric water faucets are also available.

2 answers2024-07-02

It can be, except for the beauty of the other, there is really no need, if there is a need to repair it in the later stage, it will be more troublesome, and you also have to do water and electricity when the installation workers of the washstand communicate with the home improvement construction team, what are the precautions.

1 answers2024-07-02

The (buried wall) sewer pipe under the washstand is more suitable between 20 and 50 cm from the top surface of the renovated floor to adapt to the installation of the washstand at different heights and the replacement of high-pressure water pipes and the maintenance of sewer pipes.

3 answers2024-07-02

There are countless things to worry about in decoration, from the design of the house to the choice of bathroom basin, which often puts people in a dilemma. At present, there are two common household sinks: countertop basins and undercounter basins. Many friends are very entangled when choosing a bathroom basin, is it better to have an undercounter basin or a countertop basin? >>>More