My home was just renovated this year, and I didn t think too much about it at the time, and the bath

Updated on Bathroom 2024-07-12
5 answers
  1. Anonymous users2024-01-24

    1.Normally, the bathroom is arranged with 2 circuits, one of which is the water heater circuit. The formal decoration is wires through the pipe, and you can easily replace the 4 flat wires with 6 flat wires after the decoration.

    2.If there is only 1 circuit in the bathroom, you can directly replace the 4 flat line with the 10 flat line.

  2. Anonymous users2024-01-23

    Should the bathroom ceiling be the kind that can be removed? If you can, just thread a route through the ceiling. If it is a ceiling made of waterproof gypsum board, then remove the bath bomb and wear a route, the difficulty of construction is there, but don't worry, take your time.

    Take a closer look at the power of an instantaneous water heater.

  3. Anonymous users2024-01-22

    A 4 square line should be enough, and a 4 square line can be used with a load of 8kw power. The water heater and bath bomb are about 6kw together, and you can use it for up to an hour at a time.

  4. Anonymous users2024-01-21

    Use the trunking to walk a 6 square open line.

  5. Anonymous users2024-01-20

    Did the wiring run through the pipe during the renovation at that time? Can I change the line? If you can't change it, you can only take the bright line, and the bright line is of course not as beautiful as the dark line.

Related questions
2 answers2024-07-12

After your home is decorated, why is the living room still exposed with cast-in-place boards? Or you have paved the floor tiles or plastic floors and other materials cracked together, your problem may be when you build a house, there are no problems, do you have the following situations when you cast concrete, the steel lap is too concentrated or too short, the pouring is interrupted and then the interval is too long, after the pouring concrete is used up, switch to different proportions of concrete, etc., now you can wait for the complete settlement to be processed again, remove the previous surface decoration part, sweep the slurry with surfactant, and then lay a layer of fine steel wire mesh, Make a two-centimeter mortar protective layer, do the waterproofing again, and then carry out the surface decoration part

3 answers2024-07-12

This is caused by the heating, my house has been heated this year, and everything next to the wall is wet.

1 answers2024-07-12

The exhaust gas of a gas water heater is very dangerous.

If you don't pretend to be responsible, you're afraid of responsibility. >>>More

1 answers2024-07-12

If this is demolished, it will be necessary to compensate for the loss. >>>More

5 answers2024-07-12

That piece was originally a common part, and the contract did not state that the seller was in breach of contract. You can only blame yourself for being careless.