-
Anonymous users2024-01-24Generally, it's okay, it doesn't matter once or twice, but if this is the case for a long time, the glue will naturally crack and peel off. So it's better to be careful.
-
Anonymous users2024-01-23Is the glass glue dry? Let's see what kind of glass glue you are first, the general glass glue is often washed by hot water, and it will definitely leave and crack after a long time. But if it's weather-resistant glue, it's dry.
-
Anonymous users2024-01-22If it's not a freshly installed toilet, it's okay, I hope it helps you.
-
Anonymous users2024-01-21As long as the glass glue is completely dry, there is no problem.
If it is a general glass glue, it will definitely not dry so quickly, if you buy it yourself, it is a little better glass glue, which belongs to the fast-drying type.
Install the toilet, and the sewer pipe must have a sealing ring to connect, then glue on the side, put on the toilet, and finally glue on the outer ring to seal the visible gap, if you put water two or three times at this time, it should be fine, because there is a sealing ring inside, generally the water will not run to the position between the sealing ring and the toilet wall, but I still hope to use it again in 24 hours.
Domestic bathing water and toilet flushing water are both one type. From the perspective of green energy saving, the toilet can be flushed with reclaimed water (also called reclaimed water). This will increase the cost of construction, which is rarely done in China.
Because the surface of the ceramic sanitary ware is covered with a dense glaze, the affinity between the acid silicone glass glue and the glaze is extremely poor, so it cannot be used.
It's too dark to look good.