Is the installation method of the old toilet the same as the new toilet?

Toilet installation is basically divided into the following parts:

1. Installation of toilet base:

If the toilet comes with a rubber drain ring, install the toilet drain pad on the drain pipe. If the sewer pipe is too long, it is necessary to sawn off part of it first, generally about 1 cm from the ground, and ensure that the saw mouth is flush.

Align the toilet drain with the drain pipe, gently put it on, and then adjust the position of the toilet bowl to straighten it up;

What to note here is the pit distance of the toilet. The pit distance of the toilet bowl refers to the vertical distance from the center of the toilet drain to the wall. Generally, there is a left and right appearance, no matter how much, the actual pit distance must be larger than the nominal pit distance of the toilet, otherwise the toilet can not be installed, even if it is installed, then it will be due to the misalignment of the sewer pipe outlet, which is easy to cause poor sewerage, odor and other conditions.

2. Toilet tank installation, there are some high-grade toilets, the water tank and the base are separated, then you need to install it according to the instructions in the manual; If it is conjoined, this step can be omitted;

3. Water inlet connection. The toilet must be connected to the angle valve, not directly to the water outlet. Install the angle valve first, and then connect the toilet inlet hose.

4. Sealant sealing. Then observe the toilet bowl to see if the position is regular, otherwise make appropriate adjustments. Before applying sealant, the ground and the perimeter of the base should be cleaned and kept dry, otherwise the adhesive will not be secure.

In order to ensure the appearance of the sealant...

Step 1. Before the toilet is installed, the sewage pipe should be fully inspected to see if there is any mud, sand, waste paper and other debris in the pipe.

At the same time, it should also be checked whether the ground of the toilet installation position is horizontal, and if the ground is found to be uneven, the ground should be leveled.

Step two. Flip the toilet bowl over and center it on the toilet drain.

At the same time, draw a cross centerline, which should extend to the bottom of the toilet bowl around the feet.

Step 3. Install the toilet bowl horizontally by aligning the reticle on the toilet bowl with the ground drain outlet.

At the same time, press the sealing ring tightly and install the anchor screws and decorative caps.

Step 4. Install a special sealing ring on the toilet drain.

Step five. Drain the water for 3-5 minutes to rinse the pipes to ensure the cleanliness of the water pipes.

Then install the angle valve and connecting hose.

Then connect the hose with the installed tank fitting inlet valve and press the water source.

Step 6. Check whether the water inlet valve is properly inlet and sealed.

Check whether the installation position of the drain valve is flexible, whether there is jamming and leakage, and whether there is leakage to install the filter device of the inlet valve.