-
Anonymous users2024-01-24Depending on your situation, the Higold sink can tell you that this side should be eroded by the leak-proof ring, or under-tightened;
It is recommended to take 1, replace the leak-proof rubber ring (the connection between the sink and the pipe) 2, and tighten the nut between them with a wrench or special equipment.
Finally, water is injected for testing.
1. If there is a leak in the gap under the sink bolt, you need to loosen the screws of the faucet with a tool, remove the screws, tie heads, and glands, take out the triangular gasket in the gland, and replace it with a new triangular gasket. >>>More
Sink, leakage: is the tank leaking or the side leakage, the tank is leaking, you can only replace the new sink, if the side is leaking, re-strengthen the sealing operation. >>>More
1. The faucet is not closed tightly - dripping.
The main reason for this problem is that the gasket inside the faucet is damaged, most faucet products have plastic gaskets inside, and the quality of the gaskets inside is different according to different products, but it is the same, the damaged shaft gasket can be replaced, in fact, there is no need to buy it, some plastic waste at home can be cut into the gasket the size of the faucet pipe, and you don't have to spend a penny! >>>More
Go online and buy one and come back and exchange it. My colleague used to break ours. >>>More
If there is a phenomenon of kitchen leakage, to determine whether the leakage is smaller or larger than that of eggplant, if the amount of seepage is relatively small, the area is not very large, then we only need to find the specific leakage point, and then wrap the leakage with waterproof tape or directly block it with mortar by eliminating rubber, in the process of operation, we must close all the water sources, put all the water in the faucet, dry the surrounding water and carry out construction again, In this way, there will be no problem of further in-depth development.