How to prevent moisture from insects in the toilet in summer

First, the choice of substrate.

The area of the bathroom is usually not large, and it is really difficult to separate the dry and wet in an area of a few square meters, so we have to hope for the basic materials with moisture-proof engineering. Therefore, it is recommended that the bathroom cabinet selected should have better moisture-proof performance in terms of material and technology. If a good quality product is fully ventilated, there is no problem if the humidity reaches 95% in a short period of time, because it will dry out in a short time.

Second, panel selection.

The first barrier between bathroom furniture and the humid air in the room is the furniture panel, so the advantages and disadvantages of the panel are also a problem that we need to consider. In the face of a dazzling array of panels on the market, owners must not have any choice when purchasing, and they must choose the panel that suits them. High-quality solid wood veneer and wood grain with plastic resin protection are easier to maintain and have a classic aesthetic in terms of decorative effect.

3. Internal moisture-proof.

A common phenomenon in the bathroom is that the low floor of the sink cabinet will be deformed after the bathroom furniture has been used for a period of time, because the water pipes hidden in the cabinet are not taken seriously. Because the pipe was relatively hidden, it was installed without consideration for stability, so the low waterside of the cabinet remained and soaked the furniture, creating an irretrievable situation over time. Therefore, it is necessary to use a waterproof aluminum bottom plate with a waterproof bumper strip, and this will not be the case.

Fourth, pay attention to the installation process.

Be sure to pay attention to the sanitary ware in the bathroom. While choosing bathroom furniture is important, it is only the first step, and the installation process is equally important, and if you don't do it well, it will be useless. You must know that water droplets and water vapor are pervasive, and it is best to do a good job of waterproof and moisture-proof, and you must do a good job in the installation of bathroom furniture.

In the bathroom, you can fill toilet paper with bleach, then stick it to the gap of the tiles and let it sit for a while. After making a mask for the crevices, just rinse with water to remove the mold. You can also use a bleaching detergent and apply it to a moldy area, wait about 30 minutes, and then scrub it off with a brush or toothbrush.

The bricks and brick gaps can be used to remove dirt from time to time, and then brush a layer of waterproofing agent in the gaps to prevent mold growth.

Bathroom: Baking soda to wipe.

If you find that the tiles in the bathroom are damp, you should deal with it immediately, you can use a dehumidifier to dip the clumped baking soda that is usually used for moisture absorption, dip some with a wrung out wet towel, and directly wipe the mold or stains on the wall.

Dilute the bleach used for general laundry (about 1:4 1:3 ratio to water) and wipe it on the gap between the tiles, which can easily eliminate annoying mildew!

Usually we can also make a homemade lime moisture absorption bag in the bathroom to help the tiles prevent moisture, but it should be noted that quicklime should be used, not lime for construction. Take a number of quicklime powder, wrap it in a cotton cloth or cloth bag of moderate size, sew it well, hang the small cloth bag with a rope, and hang it in a relatively humid place.