-
Anonymous users2024-01-24Pinch both sides of the lampshade and pull it down to see the built-in circlip, and then pinch the two ends of the circlip to remove the lampshade! It's simple.
-
Anonymous users2024-01-23It's the same as the gusset, it's fastened, it's very simple.
1. Check the ceiling lamp and power wiring lines. Be sure to cut off the power supply before checking the line to avoid any possible hazards. Then open the lampshade and check if the lamp fitting is loose, it is best to take the lamp off and reinstall it again. >>>More
There are many reasons why it can't be lit, such as a short circuit in the line, and a quality problem with the lamp itself >>>More
If you try to change the lamp somewhere else, it should be that the lamp is broken. The ventilation of the bathroom is not good, such as after taking a bath, it is difficult for the fog to disappear quickly, even if the lampshade is well sealed, it cannot block the fog 100%, and the natural lamp will be broken after a long time. My house has broken 3 times...
There is a driving power supply and an LED light source in the LED lamp, and the lamp is not lit when the drive power supply or the lamp source is faulty.
On both sides is a spring card, you can cancel it by deducting it down, if you just change the lamp tube, you can see the place where there is PRESS on the lampshade, press the transparent lampshade outside and it opens, I open the lamp shop, you can ask me if you have any questions.