The hot water pipe in the kitchen of the house is not working. Bathrooms are all hot water. Is it on

The installation quality is poor, and the problem can be more serious and complex than you think.

If the waterway is made by the developer, the current problems should also be solved by the developer, and all the costs and consequences incurred by the developer are completely borne by the developer, not only all the material and labor costs, but also the time loss caused by the delay in moving in.

Who designed the design? Who did the construction? Is it a developer? Or a renovation company? Whoever is responsible.

Waterproofing is done later, if there is a problem in the early stage, no discovery or rectification, it should belong to the hidden dangers left in the early stage, and should be responsible for the early stage.

There should be no problem with the three joints, otherwise the bathroom will not have hot water. Generally, there should be a design change plan after the completion of the waterway, which is conducive to finding out the problem and the attribution of responsibility.

Isn't the renovation of hot and cold water pipes done by a renovation company? If the water has come, it means that there is no problem with the entry section, which has nothing to do with the developer (usually the section of the entry that the developer does is the most likely to have problems), and the water renovation of your home should be the maximum square connection after entering the house.

This question: the plumber (decoration company) who works can be said to have no operating experience and do not use his brain. During the hot melting operation, the heating sequence of the small piece and the pipe is not understood, which causes the pipe in the small piece to melt excessively and block the small piece (elbow, tee, and bridge).

This problem is only to find a working plumber, he knows the direction of the waterway, and tells him to find the location of small pieces (elbows, tees, bridges), and can only be found in order, and it is inevitable to dismantle bricks. After finding it, tell him that when welding the pipe, it is generally necessary to insert the small piece into the hot melter for a while, and then insert it into the pipe head, (depending on which hard the small piece and the pipe are, that is, the melting time is longer, and the one should be melted first).

When dismantling, the plumber should personally dismantle carefully, and the requirement is not to hurt the waterproof layer, which is not difficult to do. This can't be operated by other people, and the degree of damage shouldn't be too great, because he should know it in his heart.

Find a good plumber to match the original.

Check the elbows of the inner teeth at both ends first, this is required, don't forget, if there is a problem with these two ends, wouldn't it be much easier?

There are two solutions: one is to smash the floor tiles and wall tiles to check and re-lay the hot water pipes, which is expensive, too troublesome, and the effect is not very good; The second is to introduce a surface-mounted pipe from the water heater to the kitchen basin, and scrap the original pipe to the kitchen basin (add a plug to block it), the cost is low, and it will not affect the decoration of the wall and the ground, and the surface-mounted pipe on the washbasin is not too long, and it will not have too much impact on the overall decoration.

First find the hot water pipe outlet of the kitchen and then check if there is anything dirty blocked, there is actually a decoration company in the construction, you can ask if there are photos of the waterway renovation, if it is the decoration company to change the water responsibility is his door, if it is the original building water pipe decoration company has not changed the responsibility is the developer, and you have no responsibility can be said to be a victim. Because I don't know your apartment type and I don't know how far away your kitchen and bathroom are, I can't guide you randomly, there will always be a way. I hope you can say it carefully.

If you can't get rid of it, it's better to get it covered in the cupboard than to smash the floor tiles.

It is easy to repair the waterproof layer, just like the mending belt, as long as you do it carefully, the general problem is not big, and there will be no sequelae.